Graphic Display Systems®
Graphic Display Systems • 308 South First Street. Lebanon,
Pennsylvania 17042 • Phone 1-800-848-3020
Assembly of our most-often-ordered sectional four
panel system.
From this to...
a 6'H x 12'W display area.
The four panels pictured, when assembled,
will create a hanging area of 6'H x 12'W.
The display panels can be set up in almost any
configuration
to meet your needs and space assignment.
Assembly of four sectional XP37 Display
Panels.
Four (XP37) Bottom sectional panels (36" high
and all tubing same size)
Four (XP37) Top sectional panels (40" high with smaller
ends)
One (1) 3-hole base
Two (2) 2-hole bases
Two (2) leg adjusters
Three (3) clips
Stage all parts ready to go. We will erect the display from left
to right.
1-Pick up a bottom panel and install a leg adjuster on the left
leg
and tighten thumb screw.
2-Insert right leg of 1st panel into the center hole of the
3-hole base.
The first panel is now free standing, supported by the
base.
3-Pick up another bottom panel and insert right leg into a 2-hole
base.
4-Put left leg into the base on 1st panel.
5-Pick up third bottom panel and insert right leg into the last
2-hole base.
6-Put left leg into base of the 2nd panel.
7-Pick up the 4th bottom panel and install a leg adjuster
on right leg and tighten the thumbscrew.
(Note that leg adjusters are used to enable the display
to be leveled on uneven ground)
8-Next install the upper panels by inserting the upper panels
directly into lower panels.
9-Install clips into the tops of panels 1 and 2,
2 and 3, and 3 and 4, to securely join panels together.
If you want to make a "U" or an "L" or other shape,
just swivel the panels to the positions desired.
You're done!
When you have done it several times, it will take about five
minutes!
Now you can hang your display items.